In techie terms: …it takes amplified speaker level signals and converts them into high quality preamp signals that can be fed into an amplifier. So now you know – its definitely possible to install a subwoofer and amplifier to your factory system, and still have it sounding good.

How do you hook up a subwoofer to a factory amp?

The Installation Process of a Powered Subwoofer to a Factory StereoStep 1: Place your sub in your vehicle. Step 2: Disconnect the battery. Step 3: Run your amp wire. Step 4: Run the turn-on wire and signal cables. Step 5: Connect the ground wire. Step 6: Handle the wiring connections. Step 7: Get into the music.

Can you connect a car powered subwoofer to an amplifier?

Both the turn-on wire and RCA signal cables need to be connected to your stereo. Run these cables behind the dash to your stereo. In this case, you can just tap into the speaker wires behind your stereo, or possibly the rear deck speakers. Either way, this will get signal to the powered subs built-in amp.

How do you wire a self powered subwoofer?

1:443:47How to install a powered subwoofer in your car | Crutchfield video YouTube

Does my car have factory amp?

There are a few ways to find out if your factory system has an amplifier system. One way is to verify if your system has more than four speakers. If it does it probably has an amplifier. You may also want to check with your factories owners manual to see what type of system that you have.

How do I know if my factory amp is blown?

These are listed below:There is a noticeable distortion in the sound.There is no sound even if you have already turned on your audio system.Your stereo system starts making bizarre sounds such as farting sounds.